에이치와이산업 - 살수, 분진 테스트 챔버 VDT 시리즈

Construction

The unit mainly consists of a cubic container with dust funnel fitted below the base.

The housing of the test chamber is made from sandwich panels. An acrylic glass door, equipped with a window wiper, is fitted to the front of the test chamber. Optimum seal of the test chamber is ensured by special rubber gaskets around the door. A grid made from galvanised steel is located above the funnel on which the specimens are placed.

The talcous dust filled into the dust chamber is blown into the test chamber by means of the recirculated air fan. The depositing fine dust particles are collected in the funnel.

On the circular, horizontal bottom of the funnel the dust is led to the opening by rotating slides radially arranged. Drive is by an exterior motor. The dust is returned to the air flow and thus to the dust chamber through a connected collector. The dust is kept dry by a heating device fixed to the floor.

The electrical section is installed in the switch cabinet fitted to the test chamber side wall. This switch cabinet will be connected to the power supply by means of a CEE-plug. The electrical section incorporates an adjustable time relay for setting of the test duration and an operating time meter.

The switch cabinet is wired in accordance with the VDE regulations.

The vacuum device will be connected to housings of type 1. It consists of the vacuum pump with a suction capacity of 4.5 l/min, an inlet filter, a flowmeter with adjustable valve as well as a pressure gauge. The setting and monitoring devices are arranged at the front side below the test chamber.

The unit is equipped with a positive displacement gas meter for measurement of the specimen's exhaust volume (measuring range 0,04 to 6 m³/h).

General

In the constant effort to improve our product, we reserve the right to make construction or design changes without notice or obligation.

Please note that for easy installation of the test chamber the exterior dimensions indicated in the technical data must be observed.

Please note that the sealing material and cable insulation used in our test units and systems contains silicone. If this is a problem for you, please contact us.

The concept and design of the test units and systems manufactured and installed by us are in accordance with the relative safety requirements and regulations of the EEC-standards for machinery 98/37/EG, EMC regulation 89/336/EWG, 91/263/EWG, 92/31/EWG, 93/68/EWG, 93/97/EWG, low voltage regulation 73/23/EWG, 93/68/EWG.

The above regulations have to be complied with also when modifications or extensions are performed on site.

* 무단수집및 복재를 금합니다 .

상품정보고시

제품명	살수, 분진 테스트 챔버 VDT 시리즈
판매가격	가격문의
브랜드	VOTSCH
제조사	독일

구입제품의 이상이 있을 경우
- 구입후 7일 이내에 동일제품으로 교환 가능하며 운송비는 판매자 부담입니다.
- 다른 제품으로 교환, 또는 이상이 없는 제품과 함께 교환을 원하실 경우 구매자께서 운송비를 부담합니다.

구입제품의 이상이 있을 경우 (색상,사이즈,다른상품교환)
- 구입후 7일이내 교환 가능하며 구매자께서 운송비를 부담합니다.

!! 주의사항
비닐포장 및 Tag의 폐기 또는 훼손 등으로 상품 가치가 멸실된 경우에는 제한.
반품시에 해당 사은품이 있을 경우 같이 보내주셔야 합니다.